Samsung Galaxy Mega
Once
the rear cover is removed, you will have access to the screws, the SD card bay
and the SIM card bay.
First,
remove the battery to turn off the phone. Proceed to remove all PH000 screws
from the exposed area as shown.
Using
your plastic prying tool, gently pry the speaker upwards and remove it. The
speaker is fragile, be careful not to break it.
Insert
the pry tool along the side of the device. Pry gently until you hear clicks.
Repeat along all sides of the phone. You will continue hearing a clicking sound
as the frame begins to release. Gently pull the battery clip up.Then slightly
twist the frame slightly clockwise as there is a little clip around the camera
that needs released. Once the back frame has been removed, the motherboard and
connectors will be exposed.
Remove
the LCD cable using your pry tool. Next, remove the front camera by unscrewing
the panel. Disconnect the front camera cable.
Get
your heat gun out and heat around the edges all around the screen Using three
guitar picks, insert them into the phone. Be careful not to insert them at the
bottom because the back button and menu button break easily, so take your time.
With
your guitar picks still in, lift the screen up towards you. Don't pull it off
right away, leave the screen at an angle Put the screen down with guitar picks
to keep it loose. Heat up the bottom to loosen the adhesive from the back and
the menu button. Once that is done, carefully pull the screen towards you and
keep an eye on the bottom to make sure the buttons are seperating from the
adhesive
Verify
the buttons separate from the adhesive, and now you can separate the screen from
the bezel. Follow the steps in reverse to put the new screen down, don't forget
the home button and top speaker silver piece.
