Motorola Slvr
L7: DISASSEMBLING PROCEDURE
Push
down on the black tab located at the top center of the Motorola phone
Remove
the battery by pulling the battery from the top center
Remove
the four (4) T6 Torx screws from the rear metal plate.
Insert
the flat end of a spudger and pry the metal cover up off the phone
Carefully,
disconnect the two connectors from their sockets on the motherboard using the
flat end of a spudger.
Use
a spudger to pry the antenna cable connectors from its respective socket on the
motherboard. De-route the antenna cable by pulling it out.
Starting
at one side, use a spudger to lift and remove the black plastic screw cover at
the bottom of the phone near the speaker The cover is attached by several
clips, so some force may be required, especially to unclip the first clip. Be
careful not to loose the round plastic piece that covers the microphone.
Remove
the 2 newly exposed T6 screws
Starting
at the top, insert the flat end of a spudger and pry the frame of the phone.
The frame is attached by several clips, so some force may be required to
dislodge the first clip. Work your tool around the entire edge of the phone,
moving as soon as you hear a clip come undone, to avoid breaking the frame.
Carefully,
Insert the flat end of a spudger and pry the keyboard up off the phone.
