Pry the back cover off with a
plastic opening tool, or your fingernail, in the indentation on the bottom of
the device.
Lift the back cover away from the
main body of the phone.
Insert your finger in the groove
below the battery.
Press the battery toward the
audio jack while lifting upward and away from the phone.
Remember to place the battery back with the copper contacts on the battery lined up with those on the phone.
Remember to place the battery back with the copper contacts on the battery lined up with those on the phone.
Using your finger, push the SIM
Card down and slide out of the slot.
Slide the SIM card out enough to
grab it firmly.
Remove the SIM card away from the phone.
Follow the visual on the bottom of the SIM card slot to put the SIM card back in the correct orientation.
When sliding the SIM Card back in the slot, make sure the card goes all the way in the slot until it hits the stopper.
Remove the SIM card away from the phone.
Follow the visual on the bottom of the SIM card slot to put the SIM card back in the correct orientation.
When sliding the SIM Card back in the slot, make sure the card goes all the way in the slot until it hits the stopper.
Using your fingernail, push the
microSD card slightly deeper into the slot, until you hear a click.
The removal of the battery is not
required for this operation; therefore, step 3 can be skipped if just replacing
the microSD card.
After the click, release the microSD card to allow it to pop out.
Remove the microSD card from its slot
When placing the microSD card back in the phone, make sure the card clicks in place.
After the click, release the microSD card to allow it to pop out.
Remove the microSD card from its slot
When placing the microSD card back in the phone, make sure the card clicks in place.
Remove the six 3 mm #00 Phillips
screws in the plastic back frame.
Slide the keyboard out.
Use a Jimmy to separate a small
segment of the plastic back frame from rest of the phone.
Starting at the bottom of the keyboard is recommended.
Slide an opening pick around the rest of the seam, starting at the gap just created with the Jimmy.
You will have to slide the keyboard back in to separate the back frame from the top have of the keyboard slider.
Lift the plastic back frame away.
Starting at the bottom of the keyboard is recommended.
Slide an opening pick around the rest of the seam, starting at the gap just created with the Jimmy.
You will have to slide the keyboard back in to separate the back frame from the top have of the keyboard slider.
Lift the plastic back frame away.
Unhook the volume rocker tether
with a pair of tweezers or the pointed end of a spudger.
The button and tether will be in
the plastic back frame.
Push the + end of the volume
rocker toward the inside of the back frame until it rolls over the "+
end" retainer feature on the frame.
You may have to use the back end
of a plastic opening tool or solid object to press the + side far enough to
release it.
New line.Lift the button out of its slot in the frame.
New line.Lift the button out of its slot in the frame.
