HKC
Tablets – HKC 7 – Disassembling procedure – How to remove the case – How to
remove the battery – How to remove the touch screen – How to remove the mother
board
HKC P776A
DISASSEMBLING
PROCEDURE
Insert
the plastic opening tool between the digitizer and the case. Place the spudger
in the gap created by the plastic opening tool to assist in separation.
Slide
the spudger along the perimeter of the device to fully separate the two pieces.
Use
your fingers to pop the screen out from the digitizer.
With
the plastic opening tool, lift the black latch up.
Pull
the optical cord out from the motherboard.
Use
your fingers to pop the screen out from the digitizer.
Use
the tip of the spudger to release the latches on the motherboard.
Remove
the cable from the motherboard.
Use
the tip of the spudger to release the latches on the motherboard.
Remove
the camera from the device.
Peel
off the tape that is attaching the wifi antenna to the case.
Using
the soldering iron, heat up the solder that is attaching the antenna to the
motheboard. The heat from the soldering iron may cause personal injury or
damage the internal components of the tablet.
Suck
up the leftover solder using the desoldering pump. Remove the wifi antenna from
the motherboard. Insert the plastic opening tool between the battery and case.
Apply leverage to break the glue that is attaching the battery to the case.
Continue
breaking the glue along the perimeter of the battery until the battery can be
removed. Breaking all the glue between the battery and case may take a long
time.
Using
the soldering iron, heat up the solder that is attaching the battery to the
motheboard. The heat from the soldering iron may cause personal injury or
damage the internal components of the tablet.
Suck
up the leftover solder using the desoldering pump. Remove the battery from the
motherboard.
Using
the screwdriver, remove the four 4mm by 1.5mm screws that are attaching the
motherboard to the case.
Remove
the black material that is covering the speaker.
Insert
the spudger into the speaker slot on the back of the case.
Push
the speaker out of the case with the spudger. Remove the motherboard from the
case.
