Locate the power button at the top of the phone. Depress power
button for 2 seconds until a menu appears.
Once the menu appears, select the "power off" option.
Wait until the phone is completely off.
Place thumb on the back cover, and push down towards the bottom of
the device. Once the cover releases, pull it away from the phone and set
it aside.
Find the yellow pull tab located in the upper left corner. Pull
the tab until the battery dislodges.
Grab the battery by the raised edge, and remove it from the case.
The battery has been successfully removed.
Remove the micro SD card from its connector.
Locate the seam between the back case and the end cover on the top
edge of the phone.
Use the plastic opening tool to detach the two clips by wedging
the tool into the right side of the seam and moving right to left. Once
the cover comes off set it aside
Repeat step on the bottom cover.
Use a T5 Torx screwdriver to remove the screws in each corner of
the phone.
The screws are very small so make sure not to lose them.
Flip the phone over and locate the screw on the middle of the left
side. Unscrew it using the T5 Torx screwdriver and set it aside.
Identify the screw located in the bottom right corner of the
battery case. Remove the screw with a T5 (or in some cases T6) torx
screwdriver and set it aside.
Locate the seam along the right edge of the phone. Use the prying
tool to disconnect the two clips along the edge.
Locate the two clips on the inside of the case and use the spudger
tool to detach them from the case. To detach each clip, use the sharp end
to press the small, black plastic in the center of the clip.
After the clips are detached, remove the back case and set it
aside.
Remove the screws along both sides of the motherboard using a
T3 Torx screwdriver. On some phones this may require a #1 Phillips
Screw Driver.
Carefully remove the white connecting wire from the motherboard
using tweezers.
Use caution, this wire is delicate.
Scrape away the electrical tape that covers the LCD and digitizer
cable using the spudger tool or a fingernail.
Use the spudger tool to pop the Digitizer cable off of
the motherboard.
Carefully flip the small white connector up and away from
the motherboard.
Gently pull the flat gold cable out from the connector.
Carefully lift the motherboard and camera module up. Do
not remove it from the phone.
Using the spudger tool, pop the black cable connector off of
the motherboard.
It is to safe remove the motherboard from the phone.
