How
to Program a DISH NETWORK Remote Control.
While
at the device location, point your remote at the device. Press and hold the
device mode button on your remote. All four mode buttons should light up.
Press
the receiver POWER button on your DISH remote. The device button should
light up.
Press
the UP or DOWN arrow on the remote (about one press per second). During the
scan, the mode light will remain lit when you are not pressing the up or down
arrow, but will go out each time the arrow is pressed. Stop as soon as the
device turns off, and proceed to step #5. This process may take several
minutes. The TV should turn off.
If
the scan has cycled through all available codes, the mode light will blink
rapidly for two seconds, and will light up only when you press the up or down
arrow. This may take approximately 5 minutes. If the scan fails to produce a
code that will control the device, advise the customer that Dish does not
currently support the equipment.
Press
the POUND (#) button. The device Mode button should flash 3 times.
Press the POWER
button on your remote to turn the device on. If this does not work, return to
step 1. The device should turn on and respond to remote commands.
How
to Program a DIRECTV Remote Control.
You
can program your DIRECTV Universal Remote to control the following: TV, Audio
components, Blu-ray player, DVD player, and VCR.
If
you have an HD DVR or HD receiver, follow these steps:
Press
MENU on your remote.
Select
Settings & Help.
Select
Settings.
Select
Remote Control.
Select
Program Remote, and then select the device you wish to program.
Follow
the on-screen prompts to complete programming your remote.
Note:
If your remote is not listed, or you need additional codes, use the code lookup
tool to the right to find the 5-digit code for your device.
If
you have a standard DVR or an SD receiver, follow these steps:
Press
MENU on your remote.
Select
Parental Favs & Setup.
Select
System Setup.
Select
Remote or Remote Control.
Select
Program Remote, then select the device you wish to program.
Follow
the on-screen prompts to complete programming your remote.
Note:
If your remote is not listed, or you need additional codes, use the code lookup
tool to the right to find the 5-digit code for your device.
