COX remote control programming procedure
Cox
Universal Remote Control is already programmed to operate your cable converter,
an RCA TV, an RCA VCR and a Pioneer audio receiver. To control devices other
than the default brands, perform the following steps to reprogram your remote…
1. Turn
on a device.
2. On
the remote control, press a device key once (e.g., AUX, VCR, or CABLE). Press
and hold SETUP until the selected mode key flashes twice, then release SETUP.
3. ENTER
the four digit code for your device found in the sidebar to the right. If
performed correctly, the selected mode key will blink twice. If the selected
mode key emits a long blink, the code is invalid. Repeat steps 2 through 3 and
try entering the same code again.
4. Aim
the remote control at the device and press POWER once. The device should turn
off. If it does not, repeat steps 2-3, trying each code for your brand until
you find one that works. If it still does not work, try searching for the code.
Repeat
steps 1-4 for each device you want the remote control to control. For future
reference, write down each working device code.
How to program a Sony remote control
4
Digit Universal Remote Control Codes For Sony TVs.
Turn on the component to be programmed by your remote.
Press the SET button on the remote control.
Press the component button for the component being programmed.
Using the number keys enter the component’s 2,3,4, or 5 digit code.
Press the ENT button.
Point the remote control at the component.
Press the POWER button to verify operation.
Sony universal codes are: 0128, 0013, 0002, 0071, 0380.
If this does not work then repeat the procedure.
Enter one code at a time until you find one that functions.
How to program a Vizio remote to control another component
1 Turn on your TV (or device you want to control)
2 Press the TV (or device) button and hold for 5 seconds until the LED flashes twice. LED will remain lit.
3 Find the code for your TV or device in the code list BELOW and enter it using the Number Buttons.
(The LED flashes once after entering each digit. If the code is accepted, the LED flashes twice after the last digit is and then turns off)
4 Point the VIZIO remote control at the device and press the POWER button. If the device powers off, setup is complete. If not, repeat steps with a different code
