Asus
MeMO Pad HD 7 – Disassembling procedure – How to replace the speaker
Disassembling procedure
Carefully
remove the back panel by using a plastic opening tool to remove the panel off
the device. Pull the back panel away from the device.
The
volume buttons can fall out of the case. Pay attention so as not to lose them.
Unlock
the ZIF connectors on the data cables.
Raise
the white locking tabs by lifting their upper edge – furthest from the battery
- they hinge across the width of the connector.
Remove the cable from its slot by gently pulling downward on the tabs.
Check that the touch screen cables are fully seated when reassembling or touch screen may have unresponsive areas.
Remove the cable from its slot by gently pulling downward on the tabs.
Check that the touch screen cables are fully seated when reassembling or touch screen may have unresponsive areas.
Locate
the battery connector by following the wires that come from the top right of
the battery. To disconnect the battery just lift up gently on the wires. Use a
spudger or blue plastic opening tool to gently
Using
a spudger carefully pry the battery up. It is glued down so slight pressure may
be needed.
The
battery has a soft casing, be careful not to tear the battery casing as
chemicals could leak out.
Unscrew
two Philip's #000 2 mm screws located on the left and right side of the speaker
housing.
Locate
the speaker wires to the left side of the battery. Remove the connector by
pulling up gently or prying with a tool if you cannot get a good grip.
