HTC
Touch Pro 2 – Disassembling procedure – How to remove the battery – How to
remove the display – how to remove the key board
Remove
the back cover by applying pressure and sliding upward. Lift the back cover up
and away from the phone.
Remove
the battery by lifting upward from the slot located on the right hand side.
Using
a T5 screwdriver, remove the four screws in corners as shown. Lift the top
portion of the rear case.
There
is a ribbon attached on the back of this part that requires caution to remove.
Using
a plastic opening tool, detach the plastic casing from keyboard. This may
require some force. Using a spudger or other thin tool, carefully pry up ZIF
connectors as shown. This will allow the black ribbons to detach from the
keyboard. Slide the two parts away from each other so that the black ribbons
slide through the slots and you will now have housing into two parts.
Peel
the off yellow ribbon slowly. Unscrew the fours screws in red squares (two in
each square) using a 00 screwdriver. After the screws are out you will be able
to easily take off the small metal pieces.
Gently
peel off the yellow tape. Carefully pull the dual black strip off using force.
Behind the dual black strip is very sticky piece of grey tape. Use tweezers
with a grip at end to peel it off, be careful not to rip the grey tape.
Lift
up the metal hinges up. Lift the keyboard frame off separating the key board
from the screen.
Unscrew
the two screws shown using a 00 phillips screwdriver. Wedge a flat head
screwdriver or metal prying tool between the flat face and rounded edge of the
phone casing. Then, slide and pry around the entire piece until the face comes
off.
Use
a spudger to lift up the three black latches that secure the flat electrical
wire. Then, pull the wire out of the latches being careful not to rip them.
Carefully, peel the silver electric tape off (force required).
